CS01-MIDI Assembly and Installation

[John]

Overview
The CS01-MIDI kit is based on the UMR kit. Because of the size of the CS01, the UMR PCB must be housed outside of the CS01. An enclosure is not included with the kit.

PCB Assembly
Follow the UMR assembly instructions for "scan high" configuration.

DIP Switch Settings
SW1 settings are ignored. Use SW2 to specify the incoming MIDI channel as described here.

Control Wiring
Connection points on the CS01 circuit board are shown in the image below.

Connect the following lines from the UMR circuit board to the CS01 12-pin ribbon cable:



Power Wiring
The UMR must be wired to the CS01 as shown in the diagram below. The zener diode 1N4734A and the 220Ω resistor are included with the kit.



CS01 PCB